Aphex 1788-R Manual de instrucciones descargar pdf (Pagina 45)

Page 44 Page 45

R/C Manual

5. 1788A R/C SOFTWARE

Step 2: Start The Software

Run the 1788A Remote Software program. If the SETTINGS call for starting up with the

previous Session, click the Blank Session box then quit and re-start the program. We

want to begin with a clean slate this time.

Step 3: Wake-up The Hardware

1. The Thumbnail Panel should already show the wake up buttons, but if not, right-click

inside the panel to show them.

2. Click the “Send Wake-up To Preamps” button and the “Send Wake-up To Controllers”

button.

3. Two thumbnails should appear to represent the 1788A’s. If out of order, drag the one

with NO11 over the first position and drop it there. They should line up in numeric order

at this point.

Step 4: Practicing With The Preamp Controls

1. Click on the NO11 thumbnail. It will outline itself in red. Its controls will be sent to the

Preamp Control Panel.

2. Click on the indicators to operate several of the on/off controls (Mute, PAD, POL, etc.)

to see how they react.

3. Click and drag over the Gain numeric readouts (Main, Aux and Input) to see how their

values change as you drag the pointer. Observe the limits of each Gain readout.

Step 5: Assign Some Groups

1. Click on the NO11 thumbnail. It will outline itself in red. Its controls will be sent to the

Preamp Control Panel.

2. On mic channels 1 and 2, drag down and select GROUP 1.

3. On mic channels 3 and 4, drag down and select GROUP 2.

4. On mic channels 5 and 6, drag down and select GROUP 3.

5. On mic channels 7 and 8, drag down and select GROUP 4.

6. Click on the NO12 thumbnail. Repeat steps 2 thru 5 for this preamp.

Figure 5-14. Wake-up

Buttons

Figure 5-15. Dragging Thumbnails Into Order

1 2 ... 40 41 42 43 44 45 46 47 48 49 50

Sin comentarios

Aphex 1788-R Manual de instrucciones Pagina 45